Arc Welding Accessories

Welding Accessories Purchasing Guide

Welding Electrode Holders & earth clamps

• The standard 400 amp electrode holder is utilised in accordance with shielded metal arc hot work (also known as stick welding), because it offers a safe and simple way to keep consumable welding rods secure.
• It is a basic and uncomplicated tool made up of a clamp and a protected grab handle.
• Whilst the clamp secures the welding rod, the welder takes control via the grab handle – the electrode holder is powered through an electrical outlet.

What are Welding Electrode Drying Ovens?

• Welding electrodes, especially low hydrogen iron powder type electrodes, are prone to absorbing moisture from the atmosphere. If there is more moisture present than the recommended levels for the particular type of flux, then the electrodes need to be re-dried before you can use them.
• This is where welding drying ovens come in. Electrodes should be placed in a welding oven for one hour at 0-250 degrees Celsius to expel the excess moisture from the flux coating, making the electrodes safe for use.

What are Welding Electrode Quivers?

• A welding quiver is an on-site, lightweight, portable oven, designed to protect the electrodes post transfer from an oven. Available with 110/240 volt input.
• Ideal for storing electrodes in warm, dry conditions before welding.
• They prevent moisture from entering low hydrogen electrodes.
• Enable accommodation of a small quantity of welding rods close to the job.

What is Arc Air Carbon Gouging ?

• Arc air gouging is a process used to cut or remove metal through intense heat which is generated from a carbon arc.
• For this process you need to use a carbon electrode, compressed air and a welding power source.
• The arc created between the carbon electrode using an arc air gouging torch and the work piece melts the metal. At the same time, the compressed air blows the melted metal away leaving you with a clean groove in the metal.